How to Fix ALL SAMSUNG QUALCOMM MIPI DEVICE FAIL Without Root (Binary 10)

Problem: MIPI Device Test fail After Unlock(Only Searching No Network)

1.Flash Combination Rom Of Same Bit(Binary).

(Note: If Flashing Failed Just Extract .pit file From combination.tar and select it in pit section).

2 .After Successful Flashing The Phone Boot Up In Factory Binary. Now Just Go To Dialer And Dial *#2763368378# Then Select 2. Ue Setting Info–>1.Setting–>2.System–>3.nv rebuid–>3.all. After That Just Restart The Device And Voilla Network Is Working In Factory Rom.

3.Now Take Any Professional Tool Like Z3x Or Octoplus(Use Model N9005) And Make A QCN Backup. First Enable Modem Port Using *#0808# And Select DM+Modem+ADB.

4.Now Flash The Phone With Respective Firmware Like G935a With G935a Or G935T With G935T. If Flashing Fails Due To Any Error Like System Size Exceeds Or Unsupport dev_type. Just Extract Pit File From CSC And Select It In Pit Option And Then Flash.

(Note: Flash With Same Model File. I Am Not Responsible For Brick Device By Flashing Wrong Model File.)

5.Now Wait For Phone For Boot Up. After That You See Again No Network And MIPI Device Fail Again. Don’t Worry Just Enable Modem Port Again And Restore QCN That We Backed Up Earlier With Same Method.

6.Restart The Phone..!!!!!

7.Voilla!!!! Network Working Fine With Stock Firmware….

SPECIAL NOTE: Use Same Model Flash File And Follow Steps Carefully If You Do Not Want To Repeat Whole Process Again.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

error

Please share & Like

RSS
Follow by Email
Facebook
Facebook